News

新闻资讯

Home page

The production of wooden handle claw hammer

2022-05-27 22:03

The wooden handle claw hammer is a widely used product in hammers, and its production process requires many precautions. Hammer manufacturers share with you the 8 major production steps of wooden handle claw hammers, hoping to be helpful to everyone.
1. Blanking. Cut cylindrical steel with L=90mm and ø=25mm, and after cutting, use a steel ruler to check the length of the material.
2. File the two end faces of the steel, place the cylindrical steel on the V-shaped iron, and use a drill bit to punch the sample hole.
3. Sawing and filing. Saw off one side of the cylinder with a hacksaw; Grind the surface flat with a flat file, leaving half of the punch hole during filing, and then cut on the other three surfaces.
4. Scribing and sawing. Using the fitter's lofting method, draw the sharp tip of the claw hammer on paper, cut off the cardboard, and stick it onto the already made raw steel for sawing and filing.
5. Scribe and file. Draw a 22mm high line segment AF on the line segment; Use a height ruler to draw a line segment AH=3mm, and use the same method to draw eight lines; File.
6. Filing and sawing. Use a flat file to file the head of a rectangular solid and grind it into a nail sized circle; Cut and file the sharp tip of the claw hammer.
7. Draw the centerline of the hole, drill and tap.
8. Drill and tap. Then use a bench drill to punch holes in the marked sample, and perform machining and tapping treatment on the left rear facing the drilling hole.

Featured News

TINQIN TOOLS showroom upgrade

Expo Nacional Ferretera 2024

Shanghai exhibition, successfully completed

Manual Tool Usage

Maintenance of manual tools

Management of tools